How To Plant A Tree Ball

This will mark the outline of the top of your ball. Select an appropriate planting site based on your trees requirements.

Texas Tree Selector Trees To Plant Landscaping Trees Texas Trees

The root flarehighest major rootshould be level with the soil surface.

How to plant a tree ball. Dont lash it too tight so the trunk cant flex in the wind. Dig a hole three times as wide as the pot and the same depth. If no roots larger than 12 inch in diameter are found by probing 2 inches deep on top of the ball plant the tree 2 to 3 inches higher than the ball depth and remove the excess soil from the top of the ball.

Loosen any bottom roots that have matted. Dig the hole only as deep as the soil ball and place the ball on undisturbed soil. Put the tree in the hole removing the burlap.

Drive the stake into the ground underneath and through the root ball. Before you start digging the hole to plant your tree measure the plants root ball. Gently lift the tree by the root ball with a partner and lower it into the middle of the hole.

P lac etr in oh. Learn how to plant a. Determine the distance out from the tree.

Dig the planting hole just as deep as the trees or shrubs container. Prepare the soil. With the hole dug and the soil around the hole thoroughly cultivated carefully remove the trees root ball from its container and using your hands gently loosen any outside roots from the sides and bottom taking care not to break or damage the root ball.

In the landscape trunk-girdling roots account for 57 of all tree deaths. 11 of root ball per one inch of tree caliper 6 above the soil. Trunk-girdling roots may.

The planting tips are. Install Tree Stakes. Use a shovel handle or yardstick to estimate planting depth.

Do not drag or drop tree roughly into hole. Replace most of the soil. The stake should be tied loosely to the trunk.

Stabilize and straighten the tree with back fill. Dont cross this line. Turn the spade backwards to the tree with the handle tilted toward the tree and start digging a shallow trench around the tree with the corner to the spade.

Make sure that you have not buried the stems of the plant and that you just covered the root ball with the soil. This will tell you how deep you need to dig the hole. How to Care for Root Ball Trees and Shrubs After Planting.

Once everything is nicely covered with soil and in its place water well and soak thoroughly. Clods in the backfill create detrimental air pockets around the root ball. The soil used to fill in around the root ball of the newly planted tree or shrub is called backfill.

Using a cultivator or garden trowel remove the top layer of soil from the root ball. In a Nutshell. Slide the root ball out of the container carefully.

Loosen and untangle any circling or snarled roots. Dig a shallow saucer-shaped hole two to three times the diameter of the root ball. S tra ig h en ol.

Large trees may need two or three stakes placed several feet from the trunk. Trunk-girdling roots develop when a tree is planted too deeply in the root ball andor the root ball is planted too deeply in the planting hole. Learn more about tree planting and care by contacting your local K-State Research and Extension office.

These are step-by-step instructions with video from a tree planting in Washington DC. Loosen the root ball to encourage roots to grow into the soil. A good rule of thumb is to add a couple of shovels for every plant.

At this point you can remove the burlap that is around the root flare or where the roots connect to the trunk. Remove all the packaging. Loosen and break up any clods of soil before backfilling.

Dig a hole based on the size of the root ball. After planting water the tree thoroughly. Water the trees root ball before planting.

Thoroughly soak the root ball in water before planting - standing it in a bucket is good for this. Leave at least 2 horizontal rings of basket to help prevent root ball damage and to maneuver tree. Your best backfill will be the loosened original soil from the planting hole mixed with 10 to 20 percent compost.

Planting trees too deeply has become an epidemic leading to the decline and death of landscape trees. Push or place the ball of tree gently into hole while using trunk to guide it. Double check to ensure the highest major root is even with the soil surface.

Learn how to plant a balled and burlapped tree. The hole should be wide enough to encourage root growth but no deeper than the root flare. Loosen the soil around the hole with a fork.